Sticker Fab F1 Special Edition Dark Galaxy Rear Fog Lamp Overlay - 2015-2021 Subaru WRX / STI

Sticker Fab has recently been exploring some new, premium overlay materials. These materials are made in the USA and feature air egress channels to help prevent bubbling during installation. This Galaxy material has tons of sparkling flake in it. This really shines in the sun.

At night you won't notice it as much unless light is being shined on it from street lights or other vehicles. Once backlit the material just acts like any other dark smoke material. Allowing just enough light to pass through.

NOTE: Does not include lamp. Precut to fit and slightly cover the edges.

Sticker Fab F1 Special Edition Dark Galaxy Overlay

Sticker Fab has recently been exploring some new, premium overlay materials. These materials are made in the USA and feature air egress channels to help prevent bubbling during installation. This Galaxy material has tons of sparkling flake in it. This really shines in the sun.

At night you won't notice it as much unless light is being shined on it from street lights or other vehicles. Once backlit the material just acts like any other dark smoke material. Allowing just enough light to pass through.

Special edition overlays are all about taking your vehicle one step further. These overlays aren't found in the wild as much because they are much more costly. Made in the USA to high standards means not every company even wants to stock them.

NOTE: Does not include lamp. Precut to fit and slightly cover the edges.

Installation

Clean your hands and clean the installation area. Keep some soapy water around so you can slide the overlay in place should your alignment be off initially. Use your fingers to push all the water and air out after you find the sweet spot.

NOTE: The water only has to have a small amount of soap in it. You can use it on the lens and the back of the overlay. You can keep a hair dryer or heat gun around to aide in speeding up the drying process. As a general rule of thumb, if the heat is burning you, it may burn the material so use light amounts of heat.