3D Carbon Fiber Vinyl Fuel Door Overlay - 2013-2021 Scion FR-S / Subaru BRZ / Toyota 86

Here's another simple modification that can change the appearance of your vehicle and add some style in minutes.

Adding a few touches to your vehicle can make a subtle difference. This 3D carbon fiber vinyl trim has an actual texture to it and is not immediately recognizable as a sticker.

The 3D carbon fiber vinyl has re-positionable permanent adhesive with an air egress design. This prevents bubbles from becoming stuck underneath the material when mounting. 5 year outdoor durability.

Installation Instructions

This requires a little bit of a DIYer touch. It's not incredibly difficult and the piece is pre-cut and the orientation (top) is labeled)

Required Items:

• 3D carbon fiber vinyl door overlay
• Hair dryer or heat gun
• Soap (dishwasher or hand soap)
• Water

Clean the surface of your fuel door. Apply a small drop of soap and water to your hands. Spread on the bottom of the 3D carbon and your fuel door. There is no need to soak both, but you should have a little on both surfaces. This allows you to move the vinyl into position easily. Once you have found the correct position, apply heat. This helps the vinyl adhere to the surface better and will allow it to be pushed around the edges of the stock fuel door. A good rule of thumb is that you should not apply much more heat than it would take to burn your hand. If it's way too hot for your hand, then it is too hot for the vinyl.

Keep using your fingers to squeegee out any bubbles and excess water. The vinyl should extend slightly over the edges and stick to the sides of the fuel door. This allows some coverage of the paint for a better look.