Sticker Fab
Sticker Fab Extended V2 Vinyl Fender Vent Overlays (Upper / Lower)
2015-2020 Subaru WRX & STI
These were made for lighter colored vehicles specifically. The small extension on the back end allows you to wrap the vinyl around the edge of your fender. This prevents your vehicle's paint color from being seen at any angle.
This modification gives your car unique, aftermarket styling with minimal effort.
Sold as left and right pairs.
Details
Extended V2 Vinyl Fender Vent Overlays (Upper / Lower)
Sticker Fab's original fender overlays were designed for ease of installation. For those extremely particular about details and/or with lighter colored vehicles, this extended version installs pretty easily still and makes sure your vehicle's paint color cannot be seen from any angle period.
A little heat from a hair dryer or heat gun will seal the deal and allow you to wrap these overlays all around your fenders.
This modification gives your car unique, aftermarket styling with minimal effort.
Installation
A heat gun or hair dryer is recommended for installation. This will make it easier to wrap the vinyl around the edge of your fender. It will stick with ease. Other than that, you want to clean the application area, including the area where the vinyl will wrap around the fenders.
Keep a mixture of soapy water handy. You will want to apply this to the back of the vinyl. It allows you to slide the vinyl around to get the perfect fit and gives the air a way to get out from under the vinyl. Once you have it in the right place, just use your fingers to push out the air and water. After this part is complete you will finish up by doing the trail edge. Go ahead and open your door so you can reach into this area. Use a little heat before your wrap it around the trail edge of the fender. It doesn't require a lot. Press the vinyl with your fingers, making sure it is secure, behind the fender.
