JDM Station
WRX Gloss Black Fender Emblems
2015+ WRX
Details
These unique emblems offer your vehicle a completely new look. Remove the factory fender vent and remove the OEM emblem. The new emblem will fit in the exact same manner.
Includes a pair of gloss black WRX fender emblems. This emblem is made with a gloss black finish. This area is not painted or coated and is in turn very durable. Includes pre-applied 3M adhesive for easy mounting.
All Emblems ship via USPS when purchased alone. This is the safest method available when not shipped with larger items in a box.
SubiSpeed Install Video
Subispeed Two Minute Tuesday Install
Optional Overlays
These overlay vinyls are easy to apply and give you the option of a variety of colors. Simply use a hair dryer / heat gun and your fingers to press the individual letters into the emblem.
Includes enough to do 4 emblems so you can save some spares.
7 customer reviews
-
Somewhat Disappointed
Cool product but they did not fit as flush as thought. Drivers side is fine while the passenger side keeps popping up even after completely cleaning the spot before installing and trying to replace the 3M tape supplied with fresh tape.
-
not the best
Emblem looks good, little rough around the edge. im giving this a low score because both of my emblems the adhesive was falling off on the back and not sticking to the emblem itself, so it sticks out and looks bad
-
Not worth it
They don't actually fit. They are too flat for the spot on the vehicle. So one side fits great the front though pops off i have tried different tape and everything but they just are not a great product!
-
Not too Shabby
They were a little tough to get in and now that they are in they do not fit as flush as the stock badges. They look great but this may be irksome to some. I got the blue inlay and that was a bit hard to put in but it took some patience to get there but it for sure looks better.
-
Inlays are worth it
Get the inlays, they're only $5 more, they make the emblems pop, and you get two full extra sets. Installation is a 4 because getting those inlays in place and pressed in hard is a bear. I used a blow dryer (not heat gun) and a wooden kabob skewer to position then press them in place. Obviously, do that before installing on the car, and take your time so they look great. See below..
-
Look great
I love the way the WRB and black looks. These emblems have a nice finish and are very easy to put on. Heat gun to loosen the OEM ones and stick on the new (and much better looking) ones.
-
Great product!
Love them! But improvements can be made on the quality and texture of this emblem. Not as smooth as stock ones