Sticker Fab
Details
Here's a low cost, simple modification that will attract a little more attention towards your vehicle.
This pinstripe mimics the one found in the special edition tS Forester model.
Installation
A wet installation is recommended. With wet installations a mixture of soap and water is recommended. Clear the application area first. Then, use one drop of dishwasher soap in a cup of water, mix, and wet the bumper area of your vehicle. Wet your fingers with this mixture and the pinstripe pieces. Simply remove the pinstripe from the backing paper and apply it to the bumper after wetting. Allow to dry.
NOTE: May not be compatible with optional rear bumper guard.
People who viewed this item also viewed
1 customer review
-
Nice!
Brings a whole new look to the otherwise dull plastic bumper
QUESTIONS & ANSWERS
No questions have been asked about this product.