GCS
Details
GCS Carbon
Some Subaru vehicles have been criticized for bland interiors. Add a little decoration to the ignition area and cover up any scratches you may have with this gloss finish carbon piece.
Installs in seconds with pre-attached 3M double sided adhesive. Clean the mounting surface, remove the tape backing from the garnish, and press firmly.
People who viewed this item also viewed
10 customer reviews
-
love the way it looks on my ignition its makes the interior pop more
-
Waste of money
so it's a big disappointment and a money waster the 3m on the back is absolutely horrible and it kinda looks cheap and fake. It'd been easy to install if it were to actually want to install
-
Cool
It gives a nice touch. lets see if it stays there. i really like the look of it
-
It’s Alright
Bought this for something to cover the key marks by ignition. It covers the ignition area alright, although the dimensions are a little off.
-
Looks good but adhesive is not
The adhesive on this piece was not good at all. I had to use superglue because no matter how long i held it or heated it, it didnt hold up on its own. Looks great though and adds nice matching flair to the inside of the car.
-
Protects your ignition area
It does the job of protecting the area around your key hole but wow, it looks fake. its almost hilarious. but whatever, you pay for the exclusiveness of it.
-
Really changes the look on the steering column
Was a perfect fit for my 2012 impreza sedan. Always wanted to dress up this part of my interior. Great price for an easily attachable part. Really stands out in the interior and prevents further key scratches.
-
Not what i expected but im pleased
I thought it was an actual piece of carbon fiber but it works like it should. I used a heat gun to help with getting the sides that were a little too long.
-
Does it's job. Doesn't quite line up
I purchased this to prevent further key scratches by my ignition. This product does that well. It doesn't fit that great since it's too large and you have to bend the edges to get it to sit right.
-
ehhh
Waited almost a month for this piece... I cleaned the area around the ignition really good and then peeled the backing and applied. I did do some pre placement and noticed the hole could have been cut smaller also it hangs over the top and bottom a little so that could have been trimmed shorter. The measurements are far from perfect. It does look nice with my shifter bezel. The 3m never stuck last night so I had to bust out the heat gun and work it for about 30 mins. cautiously and I'm pretty sure I get to go out and do more today. Just not what I expected... My expectations were a perfect fit and and a good stick, just like the steering wheel bezel.