OLM

OLM Quick Connect Plug and Play Harness for Rear Brake / Fog Lights

2013-2017 Crosstrek

$20.00

SKU: F1PNPSS-XVWe price match!

In Stock

Ships today if ordered in
48 mins

Speed up your install and leave your OEM wiring virtually unmodified.

You will earn Reward Points with this Purchase.

Details

SubiSpeed Quick Connect PnP Harness

This harness speeds up the install process for the JDM OEM rear fog lamp, SubiSpeed F1 Fog Light, GCS Rear Multifunction Light, and GCS CS Style Rear Fog / F1 Brake Light. The stock wiring harness in the WRX / STI can be hard to crimp as the area is tight. Also owners who wish to return their setup to stock at any point and time can do so easily with this harness.

The harness has OEM style connectors on both ends which allows you to install this in-line with the factory wiring. 4 extensions allow you to connect the aftermarket fog / F1 lights.

Includes 1 harness (only 1 required per vehicle) and 4 female terminals.


Models

The Crosstrek version of our harness only comes in a 4 pin setup. This setup will allow you to use the harness with any F1 / Rear fog lamp on the market currently.

Our overview video is from a similar product for a different vehicle application.

Overview Video


Wiring Information

Output wires are labeled for your convenience.

People who viewed this item also viewed

2 customer reviews

Average rating
(based on 2 reviews)
Ease of Installation
Fit / Quality
Overall Satisfaction
  1. plug and play

    By slowbaru September 27, 2022

    easy to install. Does what it's supposed to. Only thing I can add is the cabling is slightly off. I had to switch the parking and brake lights to get The proper output on my light. otherwise works Great.

  2. Wiring was incorrect.

    By NOT IMPRESSED. September 25, 2021

    On 2015 crosstrek, harness goes between light and light factory connector, Plugged mine in and everything but running lights worked. Looked at harness and noticed center wire was at bottom, needed to be in top. E-mailed cust. serv, and their reply was to just move the wire. In order to do that you need to cut factory heat shrink, pull wire, ( difficult ) and relocate, then do other end. These were supposed to be plug and play, NOT ! Bought one from another manufacture, correct wiring everything works great now.

Write Your Own Review

Only registered users can write reviews. Please, log in or register

QUESTIONS & ANSWERS

No questions have been asked about this product.

Upload images for this product