We couldn't find any results
- Use different keywords
- Double check your spelling
- Start with something less specific - you can refine your search results later
- Try changing some of your filters below:
OLM DRL / Sequential Turn Tri Bar Bezels (No Fog Hole)
2018-2020 WRX & STI
Ships for free in the 48 states
Add an LED sequential turn signal and three bright DRL bars to the front of your car. These are simple to install and can be done in less than an hour. The look is unique and different from everything that has been offered in the past.
NOTE: This model was made for vehicles without fog lights (ie STI / WRX Base).
OLM Tri Bar Gloss Black Bezels
These bezels feature a unique tri bar design with integrated sequential turn signal up top. Since 18+ STIs do not come with fog lights and neither do base 18+ base WRXs, this is an easy addition to your vehicle. Anyone with a 18+ WRX that has fog lights can opt to ditch them though.
The design inspiration this time was not from Japan. This is just a tuner style modification so that you can stand out from other vehicles.
NOTE: Light output on the tinted lens will be less than the standard lens.
Featured In Subispeed's New Products March
- Green - DRL (Positive)
- Yellow - Turn Signal (Positive)
- Black - Negative / Ground
18+ WRX Limited and STI owners we recommend modifying an add a fuse plug. More details on the "additional" tab. If you own a 15-17 WRX / STI with bumper conversion or 18+ WRX Premium / Base owner, we recommend the SubiSpeed Quick Connect wire that goes in your low beam and high beam fuse spots.
To wire up the turn signals, simply trace the turn signal wires from your LED headlights. There will be two wires behind the turn signal bulb. You can use the included taps to connect the black and yellow wires. If you want to keep you existing turn signals, leave the bulb inside the headlight housing. However, if you want the bezels to be the only turn signal, remove the bulb from the housing.
Subispeed's How To Install Video
This video for the original DRL bezels is a great start for your installation. The only added item for these are the pass through turn signal plugs which were designed for vehicles with the turn signals mounted in the lower fog light area. If you vehicle is equipped with headlights which house your original turn signals, you will need to tap those wires into the bezels.
NOTE: These bezels DO NOT have separate LED driver boxes. The electronics are all integrated into the light housing.
Add a Fuse
This single add a fuse can be connected to both green wires on the Tri Bar bezels. Please see the additional tab where we note how to run this setup on a 2018+ vehicle.
Just remove the pre-installed insulated terminals from the green wires on your bezel, strip these wires, and connect both of them to the single connection point on the end of the add a fuse.
Please see additional tab.
This ATM type of add a fuse is used in many vehicles. You can easily add an additional circuit without disturbing existing wiring.
|Additional Warranty Information||None|
OLM DRL / Sequential Turn Tri Bar Bezels (No Fog Hole) / A.70106CONFIG-PARENT Fits
1 customer review
I love the way these look on my WRX. I have not seen anyone around here with them and hadn't seen any reviews on here, so I wasn't sure about getting them. I'm glad I did. They are pricey, but the quality of them is really good. Wish I could find a way to get them to stay on with the normal headlights and not just as DRL. Installation was super easy. Took about 30 minutes all together with running and tucking the wires.