OLM
Details
OLM Carbon Fiber Hood Vent Extension V1.1
This is not the first hood scoop accent to hit the market however, we have been swarmed with ones that don't fit very well. Finally there is a good looking piece with no fitment issues.
Carbon fiber is great for creating premium accents all over the exterior and interior of a vehicle.
Installs easily with supplied 3M tape. Simply clean the application area and make sure it is free of dust, debris, and wax. Test mount the extension, prepare the tape for application, and then apply using firm pressure. Ideal application temperature is 70-100 degrees Fahrenheit. At room temperature, approximately 50% of the ultimate strength will be achieved after 20 minutes, 90% after 24 hours and 100% after 72 hours.
NOTE: 3D Carbon hood scoop overlay not included.
2 customer reviews
-
Good but does not fit perfectly
By RallyGC August 9, 2020It looks awesome but does not fit flush on the top, it is slightly off on the the top portion. Make sure to use 3M to bind the top of the vent. It does not use the OEM push in clips on the top, there is only 4 screws that go in on the bottom. Other than that, looks great but if your a perfectionist this may not be the best. It is a very small issue, but I wish they had taken the time to use the OEM push clips on the top. BTW the push clips on the hood can be warped or "soft" because of the heat of the engine. I broke about 4 out of the 5 push clips. I bought new ones to replace them, but they are very hard to get out. Also, when installed using the 3m double sided tape can be seen if you look closely on the side. It does not bother me as much as I thought it would. Still a great product!
-
Looks great but fitment not great
By Chris July 19, 2020Received this from but did not meet my expectations. Product looks great but the passenger side Of the end of hood vent extension sticks up that it does not stick to car.
