OLM
OLM Euro Style High Mount Brake Light
2015+ WRX / 2015+ WRX STI
Details
OLM Euro Style High Mount Brake Light
This high mount brake light can increase visibility and add a unique look to your vehicle. Looks best installed on a vehicle with tint on the rear window.
Change the location of your stock third brake light to the top of the rear window in 15-20 minutes. Installs easily with no technical expertise required. This piece uses a factory headliner plug and automotive grade 3M double sided adhesive to remain in place. The wiring can be run into the trunk area to meet up with the factory third brake light wiring.
Installation Note
This uses the factory headliner clips to mount. The plug and play end of the high mount lamp plugs into the extension wire that goes into the factory lamp. Please trace the factory connections until you find the plug that fits (in the trunk area).
People who viewed this item also viewed
3 customer reviews
-
Looks great but
By Kevin September 30, 2022This is not plug and play with a 2020 base wrx, the connector is VERY different; so I spliced, “cringe”! But after that it looks good just be sure to put a little sticky tape on the ends to make sure it doesn’t rattle against the window
-
Euro bar works great
By Bobby September 26, 2021I wanted something different than your usual third brake light & I came across this. It lights up good and I had a little difficulty getting the pop clips back in but other than that it fits great. Zip tied all the wires up and ran them along the side. Plug & play I would of liked to remove the whole original piece if they make a flat piece to replace it with.
-
Better then before
By NICE! August 31, 2020Love the OLM version! didn't need to even use the double sided tape. The first version was just plain out garbage. It only had one point of mounting. where the OLM ver has three with Double sided tape. The install comes with basic instructions, and plug in play so no splicing (Thus the five stars). I could of taken of the top lid on the trunk but instead routed the wire on the side and around the trunk arms as not to get pinched. There is another plug on there (not sure what it does). I just left connected to itself. the fitment is ok with out the tape. However, I am sure double sided tape can close the gap just a tad more. overall way, WAY, better then the other ver they were selling. Definitely like it with my duck bill spoiler it looks great!
