StickerFab Special Edition Dark Smoke Honeycomb Tail Light Overlays

Special Edition Dark Smoke Galaxy Tail Light Overlays

This special edition film takes the original StickerFab overlays to another level. Made in the USA, it's a super premium material with air egress channels for easier installation.

It's not a cheap material to stock so you won't find many companies working with it. The Honeycomb type has a unique pattern when lit. However, normally you can barely see that pattern.

Sold as a pair. Also fits OLM OE Plus Linear Style Sequential Tail Lights.

Sold as a pair.

Tech Tip Tuesday Installation Video

Installation Instructions

Difficulty 3 of 5

Recommended Tool(s): Heat Gun or Hair Dryer, soapy water

Clean the surface of the tail light. Use soapy water to make installation easier. Place the slightly soapy water on the tail light and the adhesive side of the overlay. Start in the middle of the tail light and apply the film. Use your fingers to squeegee out the water. It is recommended you use your fingers so you do not scratch the material. The heat can be used to allow the material to stretch AND to slightly shrink it when you're not pulling it. Massage out any creases with your fingers. You may have to pull up sections and reapply if many creases begin to appear. Keep working the material until you have 100% coverage. Average time per install is 10 minutes per side. Best to allow the vehicle to remain in the sun for some time and DO NOT POWER WASH for at least 48 hours. Some bubbles and creases may disappear over time and exposure to heat.