Sticker Fab
Sticker Fab V2 Black Out Headlight and Sidemarker Overlays
2015-2020 WRX & STI
The latest version of the StickerFab headlight overlay, completely blacks out the sidemarker and adds an eyebrow across the top of your lights.
Premium material with air egress channels. High bloss black and stretch for easy application. Precut. No additional trimming required.
NOTE: This does work with the 2018+ WRX Limited / STI headlights. Sold as a pair (left/right).
Details
Sticker Fab V2 Black Out Headlight and Sidemarker Overlays
By popular demand, Sticker Fab has given you the darkest option available for a headlight overlay. This black material is precut to allow for easy installation over your stock headlights. It will completely blacken out the sidemarker area and give the top of your headlight an eyebrow.
The material is high quality gloss black vinyl with air egress channels. These small channels make it easier to get air bubbles out. It is also stretchy and easy to conform to curves. Precut. No additional trimming required.
INSTRUCTIONS
Simply clean your sidemarkers and upper area of your headlight before application. Wet installation is highly recommended. Either use water soapy water (drop of Dawn mixed with water). Start at the corner closest to the wheels of the vehicle and work your way toward the thinner part of the overlay. Use your fingers (recommended), a felt squeegee, or credit card (if plastic wrap in paper towel to prevent scratching). A hair dryer is handy to form the vinyl where ever you need it to go and increase adhesion. It will encourage the water underneath the vinyl to dry. Allow to dry for 24-48 hours.
Once completely dry, they will hold up in automatic car washes and against most power washing.
People who viewed this item also viewed
2 customer reviews
-
Completely changes the front end.
By Rob December 19, 2021Didn't think a simple vinyl was going to make this big of a difference. Looks way meaner up front, I prefer a more subtle look instead of straight blackout since my car is gray. Install was pretty easy straight forward, Heatgun is a necessity for it to seal tightly around the edges. I recommend a warmer shaded environment for install. Its tough to get the water out in the cold. Totally recommend for anyone stuck with the ugly wrx chrome lights.
-
Super easy to apply, looks great
By Caitee September 30, 2020I've never applied a vinyl overlay before and was surprised at how easy this application was. I used a spray combo with water and dish detergent, a credit card wrapped with a microfiber lens cloth as a makeshift squeegee, and a heat gun. Took me less than 45 minutes to complete and looks great.
