Sticker Fab
Details
3D Carbon fiber Vinyl Trunk Trim Overlay
Adding a few touches to your vehicle can make a subtle difference. This 3D carbon fiber vinyl trim has an actual texture to it and is not immediately recognizable as a sticker.
The 3D carbon fiber vinyl has re-positionable permanent adhesive with an air egress design. This prevents bubbles from becoming stuck underneath the material when mounting. 5 year outdoor durability.
NOTE: Precut vinyl does not work well in this application because of the curves in the trunk trim. Having excess vinyl to hold on to and stretch makes the installation much easier. Approximate dimensions of vinyl strip is 30" by 3.5" tall.
Installation Instructions
This requires a little bit of a DIYer touch. It's not incredibly difficult. You will receive 1 strip of carbon fiber vinyl to apply to your trim.
Required Items:
- 3D carbon fiber vinyl strip
- Hair dryer or heat gun
- Xacto knife
Remove your trunk trim from your trunk (see additional tab). Clean the front surface and around the back side. The material you are working with is sticky, but can be pulled back up carefully to reposition if required. You want to align the bottom, straight edge of the vinyl with the straight portion of the trim. Center it and begin to apply it. Make sure there is a straight line across the bottom and the vinyl is long enough to reach the opposite edge. Once you have found the correct position, apply heat. This helps the vinyl adhere to the surface better and will allow it to stretch it across the top, conforming it to the curves of this trim. Do not allow the vinyl to crease, continue to stretch it using a combination of pulling and heat. A good rule of thumb is that you should not apply much more heat than it would take to burn your hand. If it's way too hot for your hand, then it is too hot for the vinyl.
Once you have covered the surface, you can trim the excess vinyl.
People who viewed this item also viewed
8 customer reviews
-
Looks Great
By Alex August 30, 2020I have a 2018 white WRX and been going back and forth between having badges and badge-less. This vinyl piece breaks up all the white when going badge-less and now I am satisfied with what the rear end looks like. The piece however does come excessively bigger than the part so you'll have to cut some the excess off but it wasn't a problem for me.
-
Great product
By Brent August 27, 2018I love the look. Just took some time to sit down and get it on heat it up and trim it. Makes the trunk pop. Very satisfied! Thank you subispeed
-
looks great
By Justin April 30, 2018Looks great with the carbon and red emblems!
-
Looks Great
By Sam March 5, 2018I had a bit of a tough time getting it to fully stretch around the bottom but if you take your time with it, it looks awesome. I would probably say that it is my favorite cosmetic upgrade that I've done, and you can't beat the price
-
Looks great
By Jacob November 6, 2017Took about 15 mintues to install they provide a great installation tutorial, its not an exact fit its bigger so you need to make the fit, but was still pretty easy and looks really good.
-
vinyl was too big
By Dongyang August 19, 2017had a hard time install this piece since the vinyl was way bigger than the trunk piece had to do a lot of cutting but it turned out great hope you guys can make it smaller to fit the trunk trim better almost like twice the size of the surface
-
Fantastic Product
By Peter February 21, 2017Looks amazing, and was not too hard to install considering it was my 2nd time working with vinyl. Really makes your trunk pop.
-
Look pretty straightforward
By Jerome December 31, 2016it was when i attach it ill take a photo
