We couldn't find any results
- Use different keywords
- Double check your spelling
- Start with something less specific - you can refine your search results later
- Try changing some of your filters below:
Sticker Fab 3D Carbon Defroster Vent Overlays
15-20 WRX / 15-20 STI / 14-18 Forester / 13-17 Crosstrek
Sticker Fab has distributed over 20,000 vinyl products in the last few years! They specialize in adding custom accents to modern vehicles.
These overlays will add texture to your dull, plastic AC vents.
Sticker Fab AC Vent 3D Carbon Blackout Overlays
Add some texture to the interior of your vehicle. Sticker Fab make a number of products for these vehicles. The 3D carbon vinyl is easy to apply and really durable. Protect areas against scratches and cover up old scratches.
Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
Lasts up to 5 years outdoors.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Clean the application area and make sure it is clear of any dirt, debris, and/or Armor All. This material is pretty forgiving during initial application. The adhesive is also pressure activated. Just keep that in mind. Finding the center is really the key to installing these. You can gently guide the material as you apply it. All you need is to use your fingers though. We don't recommend a squeegee or anything hard. The material is forgiving and can gently be pulled back up if you need to realign it.
Use of a little heat from a heat gun or hairdryer (preferred) can help increase adhesion and allow you to stretch the material if you misaligned it and just need a little extra coverage. Please use small amounts of heat.
|Additional Warranty Information||None|