Sticker Fab
Sticker Fab 3D Carbon SI Drive Trim Overlay
2015-2020 STI
These vinyl overlays are a great first mod or last touch for your build. They last for ages and can be moved whenever you feel like it.
NOTE: Includes 2 overlays. Use 1 as a backup. Trim piece not included. This is a vinyl overlay only.
Details
STI SI Drive Trim Overlay
These are great as a first mod or as a last touch to your vehicle. Cover up the plain black trim (depending on your model year) with these textured 3D carbon overlays.
For a cleaner look the two labels at the bottom have been covered.
NOTE: Includes 2 overlays. Use 1 as a backup. Trim piece not included. This is a vinyl overlay only.
Material Details
Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
Lasts up to 5 years outdoors.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Installation Notes
Clean the application area and make sure it is clear of any dirt, debris, and/or Armor All. You will want a hair dryer or heat gun for this installation. Only a small amount of heat at time will need to be applied. Remember that if it is hot enough to burn you, then it is most likely too much heat for the vinyl.
Align the upper area first and make sure it does not cover any of the writing. Our pictures will help you install it so please reference those. We only took off our knob because it had an aftermarket cover attached to it. The material is forgiving so if you lay it down and it is slightly off, just gently peel it off. Try not to press down or apply 100% until you are sure of the alignment.
Again, look at the pictures for the install tips. Do not let the lower corners to make contact until you are ready to apply a little heat and stretch them. They have to stretch to prevent creasing.